FEATURES AND CONTROLS
1.Starter Button - Depress and hold the starter but- ton to start the engine. Release it as soon as the engine starts. Do not depress for more than ten seconds at a time. NOTE: The lanyard and lock plate must be at- tached to the engine stop switch to start the engine
2.Stop Switch/Lanyard - Push this switch down or disconnect the lanyard plate to stop the engine quickly.
3.Safety Lanyard Wrist Cord - The lock plate end is attached to the stop switch. The wrist band is attached to the operator’s wrist or PFD. The engine will not start un- less both are attached.
4.Gauge Mode Button - This button operates the display change for the NGI. See page 30.
5.Throttle - Squeeze the throttle lever toward the handlebar to increase speed. Release the lever to slow the craft and return the engine to idle. NOTE: The throttle lever installed on your MSX is
6.Instrumentation - Instrumentation is New Gen- eration Instrument (NGI). See page 30 for a detailed explanation of the NGI display.
7.Seat Latch - The seat latch secures the seat in posi- tion. When released, it provides access to the engine compartment.
8.Jet Pump Outlet Nozzle - The nozzle is the exit for the jet output. Orientation is controlled by the handlebars and determines the direction of craft movement.
9.Exhaust Outlet
10.Reverse Gate
11.Drain Plugs - When water gets into the bilge, it can be drained through the drain plugs. Remove the water- craft from the water before draining the bilge. Be sure the plugs are securely installed before launching the craft.
12.Fuel Tank Fill - The fuel fill is located under the front compartment door. Turn the cap counterclock- wise to remove, clockwise to replace.
13.Oil Fill - The oil fill is located under the front compartment door. Turn the cap counterclockwise to remove, clockwise to replace.
14.Jet Pump Intake Grate - The grate protects the impeller and drive shaft and protects riders from con- tact with components.
15.Drive Shaft - Beneath the intake grate, the drive shaft transmits power from the engine to the impeller.
16.Ride Plate - The ride plate covers and protects the jet pump and provides leveling control for the craft.
24
