Mounting the base
Remove the camera unit from the base and mount the base to the ceiling or wall.
When mounting to a wall, follow the procedures by replacing areas indicated as [ceiling] by [wall] accordingly.
Setup
Drill mounting holes (R30 mm, 1 1/8 inch) using the template supplied when necessary.
R30 mm
(1 1/8 inch)
| Approx. 100 mm |
| (37/8 inch) |
Coaxial Cable |
|
| Power Supply Wire |
Alarm Signal Cable | (AC 24 V only when heater |
is in use) | |
|
1. Removing the camera unit from the base
A Unfasten the 2 fastening screws from the camera unit using a screwdriver.
B Press the 2 clips inwards to remove the camera unit from the base.
A |
B |
Clip(x 2) |
2. Mounting the fall prevention wire to the base (fall prevention wire is not supplied)
Remove the fastening screw for the fall prevention wire and mount the fall prevention wire.
Note:
●Pay attention to the length, strength, routing and material (insulation properties) of the fall prevention wire used.
●The internal diameter of the rounded portion on the camera unit to which the fall prevention wire is to be mounted shall be at least R 4.1 mm and not larger than R 6.5 mm, and its external diameter shall not be larger than R12 mm.
3. Mounting the fall prevention wire to a firm place
To prevent the camera from falling, mount the base to a firm place using the fall prevention wire.
4. Mounting the base
Mount the base by aligning the shooting direction mark on the inner side of the base (j) to the shooting direction.
When mounting to the wall, mount it with the shooting direction mark(j) facing upward. Do so by using 2 R4 mm mounting screws.
Note:
●When mounting to the wall, make sure to mount it with the shooting direction mark (j)facing upward. Failure to do so may cause the fall prevention wire of the dome cover to come off easily.
●R4 mm screws are not supplied with this product. Use appropriate type of screw according to the material of the mounting place.
3
Fall Prevention Wire
Camera |
Base |
Base | 8 mm | 2 |
|
2 mm
Align with shooting | 4 |
direction | |
(Face upward when | R4 mm screw |
mounting to the wall) |
|
,
21
