Installation and Connection

Mounting the inner dome

After setting is complete, mount the inner dome to the camera.

1. Mounting the inner dome

Mount the inner dome to the 3 clips.

Clip(x 3)

Inner

Dome

*TK-C215VP4 is used in the above illustration

Mounting the dome cover

1. Cleaning the dome cover

Before mounting, remove any dust or dirt from the dome cover.

Memo:

Dirt that is not removed from the cover before mounting may appear on the camera’s image.

Memo:

Do not apply excessive force to the dome cover such as stretching it.

2. Mounting the dome cover to the base

Mount the dome cover by aligning the 3 position marks on the base with the dome cover.

3. Fastening the dome cover

Fasten by tightening the 3 fastening screws of the dome cover using the wrench supplied.

Position Alignment Mark (x 3)

Note:

Mount the inner dome such that it does not cover the lens.

When mounting the inner dome, make sure not to move the position of the lens. Doing so may cause the preset angle of view to go out of alignment.

3 2

Wrench (Supplied)

*TK-C215VP4 is used in the above illustration

30

Page 30
Image 30
JVC TK-C215VP4U/E, TK-C215VP12U/E manual Mounting the inner dome, Mounting the dome cover