JVC TK-C215VP12U/E, TK-C215VP4U/E manual Camera Interior, Memo

Camera (Interior)

M

N

O

P

Q

R

S

T

*TK-C215VP4U/E is used in the above illustration

MRotation Knob ( TK-C215VP4U/E only)

Rotate the lens unit to adjust the inclination of the image. (A Pg. 25)

N Rotation Center Mark

(A Pg. 25)

O Fall Prevention Wire

Use this to connect the base G to the dome cover D.

P Camera Unit Fastening Screw  2

Use this to fasten the camera body R to the base G.

To remove (A Pg. 21)

Q [MONITOR]Monitor Terminal (RCA Jack)

(A Pg. 25)

R Camera Unit

S Connector for Power Supply of Heater

This is a power connector for use when the heater (sold separately: KA-ZH215) is mounted.

T Space for Heater

Memo:

●When mounting the heater (sold separately: KA-ZH215), read the instruction manual of the heater carefully before mounting.

Lens	Y
(A next page)
	X
	W

V

U

U Camera Unit Fastening Clip  2

This clip is used for fastening the camera unit to the base. When removing the base, press toward the direction indicated by the arrow to release. (A Pg. 21)

V Tilt Fastening Screw

Upon adjusting the angle of view, tighten the screw to ensure that camera’s angle of view does not go out of alignment when it is used at a location with strong vibration. (A Pg. 25)

W Shooting Direction Mark

Install the camera by aligning the shooting direction with the arrow mark.

X Lug Plate

This plate is used for fastening the silica gel. (A Pg. 24)

Y Space for Silica Gel

(A Pg. 24)

11