Method2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1.If “Y” connector cannot be attached directly to the cold water faucet, the short hose must be used.
2.Turn the cold water faucet off.
3.Attach short inlet hose to cold water faucet.
Screw on coupling by hand until it is seated on the faucet.
4.Using pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as it may damage the coupling.
5.Attach ‘Y” connector to brass male end of small hose. Screw on coupling by hand until it is seated on connector.
6.Using pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as it may damage the coupling.
7.Attach angled end of long hoses to the fi ll valve at the bottom of the dryer rear frame. Screw on coupling by hand until it is seated on fi ll valve connector.
8.Using pliers, tighten the coupling with an additional two- thirds turn.
Do not overtighten, as it may damage the coupling.
9.Check that the water faucets are on.
10.Check for leaks around “Y” connector, faucets and hoses.
Short hose (Inlet to cold water)
“Y’ connector
Long hose
01 installing your dryer
installing your dryer _17