Samsung DV337AGG user manual Electrical Connections, Replacement Parts and Accessories

Page 13

ELECTRICAL CONNECTIONS

Before operating or testing, follow all grounding instructions in the Grounding section.

An individual branch (or separate) circuit serving only your dryer is recommended. DO NOT USE AN EXTENSION CORD.

Gas models – U.S. and Canada

A 120 volt, 60 Hz AC approved electrical service, with a 15-ampere fuse or circuit breaker is required.

Electric models – U.S. only

Most U.S. dryers require a 120/240 volt, 60 Hz AC approved electrical service. Some require 120/208 volt, 60 Hz approved electrical service. The electric service requirements can be found on the data label located behind the door. A 30-ampere fuse or circuit breaker on both sides of the line is required.

If a power cord is used, the cord should be plugged into a 30-ampere receptacle.

The power cord is NOT provided with U.S. electric model dryers.

IMPORTANT:

When local codes allow, the dryer electrical supply may be connected by means of a new power supply cord kit, marked for use with a dryer, that is U.L. listed and rated at a minimum of120/240 volts, 30-ampere with three No. 10 copper wire conductors terminated with closed loop terminals, open-end spade lugs with turned up ends, or with tinned leads.

1.size of the conductors and the type of cord.

2.3/4” (1.9 cm) UL-listed strain relief

Do not reuse a power supply cord from an old dryer. The power cord electric supply wiring must be retained at the dryer cabinet with a suitable UL-listed strain relief.

Grounding through the neutral conductor is prohibited for (1) new branch-circuit installations,

(2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. (Use 4-prong plug for 4 wire receptacle, NEMA type 14-30R.)

Electric models – Canada Only

A 120/240 volt, 60 Hz AC approved electrical service fused through a 30-ampere fuse or circuit breaker on both sides of the line is required.

All Canadian models are shipped with the power cord attached. The power cord should be plugged into a 30-ampere receptacle.

It is not permissible to convert a dryer in Canada to 208 volts.

REPLACEMENT PARTS AND ACCESSORIES

If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your dryer or the SAMSUNG customer care center at 1-800-SAMSUNG (726-7864).

01 Installing your dryer

Installing your dryer _13

Image 13
Contents Gas and Electric Dryer Features What YOU Need to Know about Safety Instructions Safety instructionsImportant Safety Symbols and Precautions What to do if YOU Smell GASSafety instructions Safety information Contents Tools Needed for Installation Installing your dryerControl panel Door Adjustable leg See Exhaust RequirementsDucting Requirements Recommended Use only for short-run installationElectric and GAS Dryer Weather Hood TypeAlcove or Closet Installation Important to InstallerLocation Considerations Exhausting Mobile Home InstallationGAS Requirements Commonwealth of Massachusetts installation instructionsGrounding Electrical RequirementsGas models Electric modelsElectrical Connections Replacement Parts and AccessoriesGas models U.S. and Canada Electric models U.S. onlyModels InstallationWire system connections Final Installation ChecklistDon’t let a poor exhaust system slow drying by Dryer Exhaust TipsDoor Reversal Overview of the Control Panel Operating Instructions, tipsSelect Cycle Wrinkle PreventOption Cycle SelectorChild Lock Setting/ReleasingMY Cycle Suggested Items Suggested TEMP. Settings Installing the drying rackRack DRY Load the Dryer Properly Clean the Lint FilterGetting Started Care and cleaning Things to Avoid Special laundry tipsProblem Solution TroubleshootingCheck These Points if Your DRYER… Information Codes Code Symbol Meaning SolutionAppendix Fabric Care ChartWash Cycle Special Instructions Laundering Protecting the Environment SpecificationDeclaration of Conformity Cycle Cycle ChartSamsung Dryer Limited Warranty to Original Purchaser WarrantyWarranty Questions or COMMENTS?