Beko WMB 81442 LW user manual Maintenance and cleaning, Cleaning the water intake filters

Page 33

Maintenance and cleaning

If the holes on the bellow shown in the figure is blocked, open the holes using a toothpick.

C Foreign metal substances will cause rust stains in the drum. Clean the stains on the drum surface by using cleaning agents for stainless steel. Never use steel wool or wire wool.

A WARNING: Never use sponge or scrub materials. These will damage the painted and plastic surfaces.

7.3Cleaning the body and control panel

Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary, and dry with a soft cloth.

Use only a soft and damp cloth to clean the control panel.

7.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the rear of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in the water to enter the washing machine. Filters should be cleaned as they do get dirty.

1. Close the taps.

2.Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them with an appropriate brush. If the filters are too dirty, take them out by means of pliers and clean them.

3.Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under running water.

4.Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.

7.5Draining remaining water and cleaning the pump filter

The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and the service life of the pump will extend.

If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or in every 3 months. Water must be drained off first to clean the pump filter.

In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of the water, water may have to be drained completely.

A WARNING: Foreign substances left in the pump filter may damage your machine or may cause noise problem.

In order to clean the dirty filter and discharge the water:

1. Unplug the machine to cut off the supply power.

A WARNING: Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning risk, filter must be cleaned after the water in the machine cools down.

2.Open the filter cap.

If the filter cap is composed of two pieces, press the tab on the filter cap downwards and pull the piece out towards yourself.

Washing Machine /User’s Manual

33 / 42 EN

 

 

Image 33
Contents Washing Machine Important information or useful hints about usage Dear Customer Explanation of symbolsInstallation Important instructions for safety Environment4Maintenance and cleaning TroubleshootingGeneral safety Important instructions for safety and environmentUnplug the product when not in use Service life of your product is 10 yearsCompliance with Weee Directive Package informationDisposing of the waste product This appliance’s packaging material isYour washing machine Power cableOverview Top panel Loading door Control panelYour washing machine Package Contents Stand-by mode power W Off-mode power W Main model code Your washing machine Technical specificationsSpin speed rpm/ min., max Single Water inlet / Double Water inlet Woolmark NoAppropriate installation location InstallationRemoving packaging reinforcement Removing the transportation locksConnecting water supply InstallationConnecting to the drain 10 / 42 ENAdjusting the feet 11 / 42 ENGet damaged Installation Electrical connection Fitting a different plug12 / 42 EN 13 / 42 EN Preparation Sorting the laundry14 / 42 EN Initial use Preparation Preparing laundry for washingThings to be done for energy saving 15 / 42 ENUsing detergent and softener Preparation Correct load capacityLoading the laundry Preparation Adjusting detergent amountUse different detergents for coloured and white laundry 17 / 42 ENUsing bleaches Using starchDo not use softener and starch together in a washing cycle Do not use bleaching agent and detergent by mixing them19 / 42 EN Preparation Tips for efficient washingOperating the product Display symbolsControl panel On / Off buttonProgramme selection Operating the product Preparing the machineMain programmes Additional programmesOperating the product Operating the product Special programmes Temperature selectionSpin speed selection 23 / 42 EN24 / 42 EN Operating the product Programme and consumption tableOn the panel 25 / 42 ENPrewash Operating the product Auxiliary function selectionExtra Rinse 26 / 42 ENTime display Progress of programme Operating the product Starting the programmeLoading door lock Changing the selections after programme has startedMachine is in Rinse Hold mode Cancelling the programmeChild Lock End of programme30 / 42 EN Your machine is equipped with a Standby Mode31 / 42 EN Quick User GuideCleaning the detergent drawer Cleaning the loading door and the drumMonths Cleaning the water intake filters Maintenance and cleaningCleaning the body and control panel Draining remaining water and cleaning the pump filterInstall the filter Pull the emergency draining hose out from its seat34 / 42 EN 35 / 42 EN TroubleshootingProgramme cannot be started or selected Machine does not fill with water36 / 42 EN TroubleshootingIt does not rinse well 37 / 42 ENDetergent residue in the detergent drawer 38 / 42 ENWater pressure is low. Check the water pressure Foam is overflowing from the detergent drawerLoading door may be open. Close the loading door On / Off button might not be pressed. Press On / Off button39 / 42 EN Machine does not start. Nothing appears on the display40 / 42 EN Complying Commission Delegated Regulation EU No 1061/20141 / 42 EN 42 / 42 EN Washing Machines ServiceWashing Machines, Dishwashers and Electric Cookers Guarantee