Beko WMB 81442 LW user manual Child Lock, Cancelling the programme, Machine is in Rinse Hold mode

Page 29
The loading door will not open if the water temperature in the machine is high or the water level is above the door opening.

Operating the product

4. Close the Loading Door.

5. Make changes in auxiliary functions, temperature and speed settings if necessary.

6. Press Start / Pause / Cancel button to start the machine.

C

5.17 Child Lock

Use Child Lock function to prevent children from tampering with the machine. Thus you can avoid any changes in a running programme.

C You can switch on and off the machine with On / Off button when the Child Lock is active. When you switch on the machine again, programme will resume from where it has stopped.

To activate the Child Lock:

Press and hold 2nd and 4th Auxiliary Function buttons for 3 seconds. “Con” appears on the display.

C Same phrase will appear on the display if you press any button when Child Lock is enabled.

To deactivate the Child Lock:

Press and hold 2nd and 4th Auxiliary Function buttons for 3 seconds. “COFF” appears on the display.

C Do not forget to disable the child lock at the end of the programme if it was enabled before. Otherwise, machine will not allow to select a new programme.

5.18 Cancelling the programme

Press and hold Start / Pause / Cancel button for 3 seconds. Start symbol flashes. Symbol of the step at which the programme was cancelled remains lit. "End" appears on the display and the programme is cancelled.

C If you want to open the loading door after you have cancelled the programme but it is not possible to open the loading door since the water level in the machine is above the loading door opening, then turn the Programme Selection knob to Pump+Spin programme and discharge the water in the machine.

5.19 Machine is in Rinse Hold mode

Spin symbol flashes and Pause symbol illuminates when the machine is in Rinse Hold mode.

If you want to spin your laundry when the machine is in this mode:

Adjust the spin speed and press Start / Pause / Cancel button. Pause symbol disappears and Start symbol appears. Programme resumes, discharges the water and spins the laundry.

If you only want to drain the water without spinning:

Just press Start / Pause / Cancel button. Pause symbol disappears. Start symbol appears. Programme resumes and discharges the water only.

5.20 End of programme

“End” appears on the display at the end of the programme. Symbols of the programme steps remain lit. Auxiliary function, spin speed and temperature that were selected at the beginning of the programme remain selected.

Washing Machine /User’s Manual

29 / 42 EN

 

 

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Washing Machine Important information or useful hints about usage Dear Customer Explanation of symbolsInstallation Important instructions for safety Environment4Maintenance and cleaning TroubleshootingGeneral safety Important instructions for safety and environmentUnplug the product when not in use Service life of your product is 10 yearsCompliance with Weee Directive Package informationDisposing of the waste product This appliance’s packaging material isYour washing machine Power cableOverview Top panel Loading door Control panelYour washing machine Package Contents Stand-by mode power W Off-mode power W Main model code Your washing machine Technical specificationsSpin speed rpm/ min., max Single Water inlet / Double Water inlet Woolmark NoAppropriate installation location InstallationRemoving packaging reinforcement Removing the transportation locksConnecting water supply InstallationConnecting to the drain 10 / 42 ENGet damaged Adjusting the feet11 / 42 EN 12 / 42 EN Installation Electrical connectionFitting a different plug 13 / 42 EN 14 / 42 EN PreparationSorting the laundry Initial use Preparation Preparing laundry for washingThings to be done for energy saving 15 / 42 ENLoading the laundry Using detergent and softenerPreparation Correct load capacity Preparation Adjusting detergent amountUse different detergents for coloured and white laundry 17 / 42 ENUsing bleaches Using starchDo not use softener and starch together in a washing cycle Do not use bleaching agent and detergent by mixing them19 / 42 EN Preparation Tips for efficient washingOperating the product Display symbolsControl panel On / Off buttonProgramme selection Operating the product Preparing the machineMain programmes Additional programmesOperating the product Operating the product Special programmes Temperature selectionSpin speed selection 23 / 42 EN24 / 42 EN Operating the product Programme and consumption tableOn the panel 25 / 42 ENPrewash Operating the product Auxiliary function selectionExtra Rinse 26 / 42 ENTime display Progress of programme Operating the product Starting the programmeLoading door lock Changing the selections after programme has startedMachine is in Rinse Hold mode Cancelling the programmeChild Lock End of programme30 / 42 EN Your machine is equipped with a Standby Mode31 / 42 EN Quick User GuideMonths Cleaning the detergent drawerCleaning the loading door and the drum Cleaning the water intake filters Maintenance and cleaningCleaning the body and control panel Draining remaining water and cleaning the pump filter34 / 42 EN Install the filterPull the emergency draining hose out from its seat 35 / 42 EN TroubleshootingProgramme cannot be started or selected Machine does not fill with water36 / 42 EN TroubleshootingIt does not rinse well 37 / 42 ENDetergent residue in the detergent drawer 38 / 42 ENWater pressure is low. Check the water pressure Foam is overflowing from the detergent drawerLoading door may be open. Close the loading door On / Off button might not be pressed. Press On / Off button39 / 42 EN Machine does not start. Nothing appears on the display40 / 42 EN Complying Commission Delegated Regulation EU No 1061/20141 / 42 EN 42 / 42 EN Washing Machines ServiceWashing Machines, Dishwashers and Electric Cookers Guarantee
Top Page Image Contents