Electrolux EWD 1419 I Electrical connection, Permanent connection, Blue- Neutral Brown- Live

Page 29

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely. Should the appliance power supply cable neeed to be replaced, this must be carried out by our Service Force Centre.

Note

When the appliance is installed the power supply cable must be accessible.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

N

13 A

L

BROWN

BLUE

 

 

CORD CLAMP

P1041

 

 

 

29

Image 29
Contents Instruction Booklet Use InstallationChild Safety Contents Interest Environment Your New Washer-DryerEcological hints Detergent dispenser drawer Child safety featureDescription of the Appliance MAINS-ONlight Control PanelON/OFF button Prewash buttonQuick wash button Delay start buttonNight cycle button Sensitive buttonSelected drying time is displayed in minutes Now you can select a new programmeEnd of programme Programme selector dialAltering an option or a running programme Cotton Synthetics DelicatesOpening the door after the programme has started Programme informationInterrupting a programme Operating Sequence Switch the machine onLoad the laundry Select the required programmeSelect the Spin speed or Rinse Hold option Select the Delay Start optionSelect the required options Start the programmeAutomatic washing and drying NON-STOP programme Drying only1000g = 1 kg Washing and Drying HintsLaundry and placed in the tumble dryer Which detergent?Which form? Important Notes Wash Care SymbolsType Programme Additional Max Washing ProgrammesFabric Description MinAdditional Max Special ProgrammesProgramme description Functions Load Night cycle optionType of fabric Max. load Spin speed Drying time Drying ProgrammesExtra dry Store dryMaintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working 0870 5 Service & Spare PartsSymptom Possible causes Standard guarantee conditions Guarantee ConditionsEuropean guarantee CustomerTechnical Specifications Installation InstructionsWashing DryingUnpacking Install the machine on a flat hard floorPositioning Water inletJoining piece must have an internal diameter of 18mm Water drainageInto a drainage standpipe StandpipeInterest of the environment LevellingSpecial conditions Blue- Neutral Brown- Live Electrical connectionPermanent connection Building-in Preparation and assembly of the doorDrill four fixing holes see Fig. G Electrolux plc