16electrolux use
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the Start/Pause button.
(Only the Time Manager 
option cannot be modified after the programme has started. )
Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position. The washing water in the tub will not be emptied out.
Start the new programme by pressing the Start/Pause button again.
Interrupting a programme
Press the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. You can now select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button.
If the «Door» 
pilot light goes off, the door can be opened.
If the «Door» 
pilot light stays on, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O».
After about 3 minutes the door can be opened (pay attention to the water level and temperature!).
At the end of the programme
The machine stops automatically, the Start/Pause light goes off and a flashing “0.00” will appear on the.
If the Rinse Hold” 
or Night Cycle
options have been selected, the
“Door” 
pilot light illuminates, a flashing «0.00» will appear on the display, the Start/Pause light goes off and the door remains locked to indicate that the water must be emptied out before opening the door.
To empty out the water please read the steps on the Night Cycle option paragraph.
Turn the programme selector dial to «O» to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.