Electrolux 74825 manual Water inlet, Water Drainage, Open the porthole and extract the inlet hose

Page 33

Water inlet

Attention!

•An inlet hose is supplied and can be found inside the machine drum.

•Do not use the hose from your previous machine to connect to the water supply.

•This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Important!

Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.

3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

4.Connect the hose to a tap with a

3/4” thread.

Always use the hose supplied with the appliance.

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece“ supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

Important! It is essential to lay the drainage hose without kinks.

33

Image 33

Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsPrior to using the appliance for the first time SafetyChild safety Follow the Installation and connection instructionsResulting overheating may constitute a fire hazard General safetyControl panel Description of the applianceRefresh Programme overviewApplication/Features Care Symbols1 Preparing and sorting washing Before the first washPreparing washing Sorting washingOpening the door/loading washing Running a wash cycleAdding detergent /conditioner Open the door pull the handle on the doorSwitching on the appliance/selecting a programme If you are using liquid detergentWashing powder/tablets for the main wash cycle Changing the spin speed/selecting rinse hold Selecting additional programmesShortened wash programme for lightly soiled items PRE Wash Setting the delay timerProgramme sequence Starting a programmeInterrupting a programme/adding washing Interrupting a programmeEnd of the wash cycle/removing the washing OverdosingIf Rinse Hold has been selected Cleaning and maintenance Child safety deviceCleaning procedure Deactivating the child safety deviceDetergent dispenser drawer Clean the glass in the door and the rubber collar regularlyWashing drum Door and rubber collarWhat to do if Remedying small faults yourselfBeen removed There are grey stains on the washing If the wash result is not satisfactoryFoam can still be seen following the final rinse There are white residues on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Disposal Packaging materialOld appliance Consumption values Technical dataThis washing machine cannot be built-in Safety information concerning installationWhen using a sack trolley to transport the washing machine Installing the applianceTransporting the appliance UnpackingPage Remove the bracket D Tighten up the six smaller bolts C Making the appliance level Where to installElectrical Connection Brown Live Wire coloured green and yellowConnecting to the water supply Permanent ConnectionPermitted water pressure Water inlet Water DrainageOpen the porthole and extract the inlet hose From your Service Force Centre Pumping heights of over 1 metreFor drainage into an outlet Great Britain Guarantee/Customer ServiceLU4 9QQ European GuaranteeMagyarország +36 Page Customer Care 0870 5 929For general enquiries concerning Major Appliances132 977 Subject to change without notice