Electrolux 74950 user manual Positioning and levelling, Water inlet

Page 42

42Installation

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

HEC007S

If it is impossible to avoid positioning the machine next to a gas cooker or coal- burning stove, an insulating panel covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0. The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.

Carefully level by screwing the adjustable feet in or out.

Automatic foot: The rear foot on the left-hand side of your washing machine is built as a shock absorbing foot, which is why the appliance gives in the back left- hand corner if put under load. The automatic foot guarantees that the appliance does not move even at high spin speeds. Basically the automatic foot does not need to be set.

Water inlet

An inlet hose is supplied and can be found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.

HEC0006

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Lavamat Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsSafety information Prior to using for the first timeGeneral safety Installation UseChild Safety Product description Detergent dispenser drawerControl panel OK buttonTime option symbol DisplayDelay Start symbol Child Safety Lock symbol Display shows the following informationFirst Use Acoustic signalsChild safety lock PersonalizationMeasure out the detergent and the fabric softener Daily UseLoad the laundry If required, pour fabric softener intoSelect the temperature button 16 Use Sensitive option Prewash optionStain option Select an additional rinse Extra RinseSelect the Delay Start by pressing the button Press the START/PAUSE buttonInterrupting a programme Cancelling a programmeAltering an option or a running programme Opening the door after the programme has startedAt the end of the programme Washing programmes DelicatesType of laundry Programme Economy, lightlyProgramme information Easy Iron PlusOFF Sorting out the laundry TemperaturesPreparing the wash cycle Before loading the laundryMaximum loads Laundry weightsFollowing weights are indicative Removing stainsDetergents and additives Quantity of detergent to be used Degrees of water hardnessMarked before starting the wash programme Care and cleaning Washing drum Door sealDrain pump Water inlet filter Frost precautions Emergency emptying outPossible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption value Installation UnpackingSix smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOperation of the appliance Drain hose must not be kinked Joining piece must have an internal diameter of 18 mmJoining piece must have an internal diameter Interest of the environment Electrical connectionPermanent connection Brown LiveOld machine Environment concernsPackaging materials Ecological hintsSubject to change without notice
Top Page Image Contents