Electrolux U28190 manual Electrical connection, Permanent connection

Page 28

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the bottom of the rim of the open door.

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

 

13 A

N

L

 

BROWN

BLUE

P1041

CORD CLAMP

 

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Should the appliance power supply cable need to be replaced, this must be carried out by our Service Force Centre.

Note

When the appliance is installed the power supply cable must be accessible.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

28

Image 28
Contents Tpefkd=j`efkb= Important Safety Information Contents Your New Washing Machine Description of the appliance Temperature button Temp Spin Speed button SpinDelay start Button Selecting the Delay StartCancelling the delayed start Options ButtonDisplay Incorrect option selectionStart Button LightStart PauseSwitch the machine on and OFF Select the temperaturePlace the laundry in the drum Measure out the detergentSelect the Delay Button How to change a programme during its cycleHow to interrupt a programme during its cycle Select the spin speed or Rinse Hold OptionCancelling a programme End of programmeWashing Hints Which detergent? Which form?Wash Care Symbols FabricXpress60 CottonEconomy SyntheticsRinse Delicate RinseDrain SpinMaintenance and Cleaning Cleaning the water inlet filter Emergency emptying outMachine does not StartFill Machine fills thenUnsatisfactory washing results Machine vibrates or is noisyDoor will not open Spinning starts late or0870 5 Service & Spare PartsCustomer Care Department European guarantee Guarantee ConditionsExclusions Installation Instructions Technical SpecificationsPositioning Installation on a Suspended FloorUnpacking Appliance must be connected to a cold water supply Into a drainage standpipeLevelling Special conditionsInterest of the environment Onto a sink outlet spigotElectrical connection Permanent connectionElectrolux Group. The world’s No choice