Electrolux U28190 manual Options Button, Delay start Button, Selecting the Delay Start

Page 7

There are two possibilities to drain out the water.

Select the programme “Drain”

The water is drained out without spinning

Select programme “Spin” or “Delicate Spin”

Select the spin speed by means of the relevent button and press the “Start” button. The water is emptied out and the laundry is spun at the selected speed.

Attention: Before selecting “Drain”, “Spin” or

“Delicate spin” programme, the selector dial has to

be positioned on “Off”.

5. Options Button

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before pressing the “Start” button.

When these buttons are pressed, the corresponding LED will light up. When they are pressed again, the corresponding LED goes out.

If an incorrect option is selected, the LED flashes for about 2 seconds and the message Err is displayed. Press these buttons to select the following options:

1.Prewash: Select this option if you wish your laundry to be prewashed before the main wash (not available for wool, handwash, mini programme and silk programmes.

The Prewash ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained.

2.Quick: This option can be used for lightly soiled (not for wool, hand wash, silk and miniprogramme) in order to obtain a good washing programme in a short time. The washing time will be reduced according to the type of fabric and the selected temperature.

3.Rinse: This option can be selected with all programmes, except the wool and handwash programme. The machine will add 2 rinses for cottons and 1 rinse for synthetics, delicates and silk programme. This option is recommended for people who are allergic to detergents, and in areas where the water is very soft.

4.Easy Iron: Selecting this option the laundry is gently washed and spun to avoid any creasing in this way ironing is easier.

6. Delay start Button

The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours by means of this button.

Selecting the Delay Start

Select the programme and the required options.

Select the delay start.

Press “Start” button: the machine starts its hourly countdown.

The programme will start after the selected delay has expired.

Delay Start cannot be used with “Drain”, “Spin” or “Delicate spin”.

Cancelling the delayed start

Press “Start” button.

Press “Start” button until “0’” is displayed.

Press “Start” button again.

7

Image 7
Contents Tpefkd=j`efkb= Important Safety Information Contents Your New Washing Machine Description of the appliance Spin Speed button Spin Temperature button TempOptions Button Delay start ButtonSelecting the Delay Start Cancelling the delayed startIncorrect option selection DisplayPause Start ButtonLight StartMeasure out the detergent Switch the machine on and OFFSelect the temperature Place the laundry in the drumSelect the spin speed or Rinse Hold Option Select the Delay ButtonHow to change a programme during its cycle How to interrupt a programme during its cycleEnd of programme Cancelling a programmeWashing Hints Which form? Which detergent?Fabric Wash Care SymbolsSynthetics Xpress60Cotton EconomySpin RinseDelicate Rinse DrainMaintenance and Cleaning Emergency emptying out Cleaning the water inlet filterMachine fills then Machine does notStart FillSpinning starts late or Unsatisfactory washing resultsMachine vibrates or is noisy Door will not open0870 5 Service & Spare PartsCustomer Care Department European guarantee Guarantee ConditionsExclusions Technical Specifications Installation InstructionsPositioning Installation on a Suspended FloorUnpacking Into a drainage standpipe Appliance must be connected to a cold water supplyOnto a sink outlet spigot LevellingSpecial conditions Interest of the environmentPermanent connection Electrical connectionElectrolux Group. The world’s No choice