13. Cancelling a programme
Turn the selector dial to position «Off» to cancel a
programme which is running. Now you can select a
new programme.
14.How to open the door during the cycle of a programme
You can open the door, after having set the washing machine to PAUSE phase, by pressing “Start” button provided the following conditions exist:
1)the washing machine is not in the heating phase beyond 55°C
2)the level of the water is not high;
3)the drum is not turning.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
15. End of programme
The washing machine stops automatically at the end of the programme giving an audible signal.
If the Rinse hold 
option has been selected, the LED of the “Start” button goes off, the LED 
and the “End” LED remain lit to indicate that the water must be drained before opening the door. The display shows a flashing zero.
To empty out the water you can select programme “Drain”, the water is emptied out without spinning or select programme “Spin” or “Delicate Spin”. Select the spin speed by means of the relevant button and then press the “Start” button.The water is emptied out and the laundry is spun at the selected spin speed.
Turn the programme selector dial to position «Off» to switch the machine off.
Remove the laundry from the washing machine. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry.We advise you to close the water supply tap and disconnect the plug from the socket.Leave the door ajar in order to air the washing machine.
12