Troubleshooting
Installation
Problem | Possible Cause | Repair procedure | ||
|
|
|
|
|
1. Machine vibrating | 1a. | Shipping brackets not | 1a. | Open back of machine, remove 4 shipping |
or vibrating noise | removed | brackets connecting cabinet to drum | ||
|
|
|
|
|
| 1b. | Machine not leveled | 1b. | Adjust front leveling legs and tighten |
|
|
| locknuts | |
| 1c. Machine installed on uneven | 1c. Adjust leveling legs | ||
| floor |
|
| |
|
|
|
|
|
| 1d. | Machine installed on wood | 1d. | Move machin to a more appropriate location |
| floor | or install underlayment | ||
| 1e. | Rubber cap missing from rear | 1e. | Install new ribber foot |
| foot |
|
| |
2. Water leaking | 2a. | Door not screwed in properly | 2a. | Screw door in properly |
from door |
|
|
|
|
| 2b. | Door not aligned | 2b. | Align door and screw in properly/Replace |
|
|
| with new door | |
|
|
| ||
| 2c. Boot leaking | 2c. Change boot (porthole diaphrgm) | ||
|
|
| ||
|
| Wash Cycle | ||
Problem | Possible Cause | Repair Procedure | ||
|
|
|
|
|
1. Won't fill | 1a. | No power input. | 1a. | Check that the cord is plugged in, and circuit |
|
|
| breaker or fuse is OK. Test unit power switch. | |
|
|
|
|
|
| 1b. | No water pressure. | 1b. | Check that fill hoses are connected that the |
|
|
| water supply is turned on, and hoses are not | |
|
|
| kinked. | |
| 1c. Drain outlet below 20" (water | 1c. Route drain hose through a clamp on the | ||
| siphoning out) | rear of the machine, at least 24" above the floor. | ||
|
|
|
|
|
| 1d. | Door not closed tightly | 1d. | Close door firmly, so that it latches. |
|
|
|
|
|
| 1e. | Door Switch/Lock. | 1e. | Set to start of regular wash cycle. Test for |
|
|
| 115 vac between the common (low) side of the | |
|
|
| water inlet valves & terminal 21 of the pressure | |
|
|
| switch. If not present, the door switch may be | |
|
|
| defective. | |
| 1f. Pressure Switch. (test with no | Set to start of the regular wash cycle. Test for | ||
| water in the tub) | 115 vac between the common (low) side of the | ||
|
|
| water inlet valves and terminal 22 of the | |
|
|
| pressure switch. If not present, the pressure | |
|
|
| switch may be defective. | |
2