Equator EZ 2500 C, EZ 3600 C/CEE, EZ 1500 service manual Dry Cycle

Problem	Possible Cause	Repair Procedure
		11a.Unplug unit. With excessive water still in
11. Machine	11a. Pressure Switch.	tub, check for continuity between terminals 21
overfills.		and 22. Drain machine, then replace pressure
		switch if test indicates continuity.
	11b. Pressur Switch Hose.	11b.	Drain machine, then replace pressure
		kinked or leaking switch hose.
12. Door won't	12a. Door lock enabled.	12a.	Water in tub. See Won't drain.
open.
		12b.	Unplug unit, wait 2 minutes to release door
	12b. Pressure Switch.	lock. Test switch with pressure hose off. There
		should be no continuity between terminals
		11&13.
13. Clothes wet
at end of wash	13a. Water in tub.	13a.	See Won't drain.
cycle.
	13b. Inadequate final spin.	13b.	See Won't Spin.

	Dry Cycle
Problem	Possible Cause	Repair Procedure
1. No tumble	1a. No power input.	1a. Check that cord is plugged in, and circuit
action.		breaker or, if fuse is OK. Test unit power switch.
	1b. Door not closed.	1b. Close door firmly, so that it latches tightly.
		1c. Close the door. Test for 115 vac between
	1c. Door switch.	terminal a of the dryer timer and the common
		(low) side of the water inlet valves.
		1d. Set dry timer to 60 minutes. Test for 115 vac
	1d. Dry timer.	between terminal al of the dryer timer and the
		common (low) side of the water inlet valves.
	1e. Belt.	1e. Check belt, adjust tension.
		1f. Test signals at the Control Module. See
		Testing the Control Module. If correct, replace
	1f. Electronic Control	the control module. If tests on terminals 1 to 7
		fail, replace timer. Tests on terminals 8, 9 or 12
		through 15 fail, replace motor.
	1g. Motor.	1g. Check motor resistance. See Testing the
		Drive Motor.
2. Clothes cold
and damp at the	2a. Timer not advanced beyond	2a. Set dryer timer for times longer than 15
end of the dry	the cool-down period.	minutes.
cycle.

5