2. PRINTER SETUP
ENGLISH VERSION
2.7 Loading the Media
2.7Loading the Media (Cont.)
Strip mode (Option):
When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed.
•How to set the media
When issuing labels in the strip mode, set the label in the following procedure:
1.Load the media as described on the previous pages.
2.Open the Strip Block by pulling it out.
NOTE:
When the media is correctly set, the backing paper is supposed to be pinched by the Platen and the Strip Feed Roller as shown below.
Strip Plate
Label
Strip Feed Roller
Platen
Strip Block
3.Feed the paper through the Media Guide until it extends past the platen.
4.Remove enough labels from the leading edge of the media to leave about 200 mm of backing paper free.
5.Pass the backing paper over the Platen and the Strip Plate, and insert the leading edge of the backing paper into the Backing Paper Slot.
Backing Paper Slot |
| Backing Paper | |||||
|
| Strip Plate |
| ||||
|
|
|
|
| Strip Feed Roller | ||
|
|
| Platen |
|
|
| |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Backing Paper
6.Close the Strip Block and Top Cover.
