APPENDIX 1 SPECIFICATIONS
ENGLISH VERSION
A1.3 Media
A1.3.3 Detection Area of the Reflective Sensor
The Reflective Sensor is movable within the full range of the media width.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.
<Black Mark>
Sensor should be positioned at the centre of the black mark.
Min. 2 mm
Min. 8 mm
Detecting the black marks on the back.
Media feed direction
Sensor is movable within the full range.
Rectangular holes or oval holes are also acceptable only if they are positioned at the centre of the media. In that case, nothing must be printed on the reverse side of the media.
<Rectangular/Oval Hole> | Centre of media |
Sensor should be positioned at the centre of the rectangular hole.
Min. 2 mm (Min. 6 mm:
Cut mode)
Min. 8 mm
Rectangular holes (Oval holes are also acceptable.)
Media feed direction
EA1- 4
