2. PRINTER SETUP
ENGLISH VERSION
2.7 Loading the Media
2.7Loading the Media (Cont.)
NOTES:
1. The selected sensor type is the one used in the last print job. The Feed Gap Sensor has been selected as the factory default. To change the sensor type, refer to Section 2.9.1 Media Sensor
Calibration.
2. When the Media Guides are fitted to the media edges, the Feed Gap Sensor is positioned at 6 mm from the right end of media.
6 mm
3.The Black Mark Sensor is movable in a range of media width.
11.After loading the media, manually set the Media Sensor to the correct position.
The Feed Gap Sensor is included in the right Media Guide. Position of the Feed Gap Sensor can be set by fitting the Media Guides to the media ends.
Feed Gap Sensor (in the
Media Guide)
Black Mark Sensor
When using the Black Mark Sensor, it should be positioned in line with the centre of the black marks on the reverse side of the media.
Black Mark Sensor is movable in the full range.
CAUTION!
To separate the printed media from the media roll in batch mode, be sure to tear off the media at the Media Outlet or cut the media past the Strip Plate. If you tear off the media at the Print Head by mistake, be sure to feed one label (10 mm or more) with the FEED/PAUSE Button prior to a next issue. Failure to do this may cause a paper jam.
There are three issue modes available for this printer.
Batch mode:
In the batch mode, the media is continuously printed and fed until the number of media specified in the issue command has been printed.
E2- 9
