2. Installation
2.8.6 Slave Mode
(1)Ensure that the board is connected to the fieldbus. Then, start the applicomIO console application.
(2)Select Description Properties.
(3)Select the “Profibus, Slave” in the Cannel Properties dialog and click the OK button.
NOTE
)
Though you can select the “Profibus, Master/Slave” as a slave, it might not communicate properly in some Master.
To use only the slave function, select the “Profibus, Slave”.
(4) Click on the “Protocol list” under the board that was just added.
(5)Select Protocol Properties.
Fieldbus I/O Rev.6 | 51 |
