Epson EM07ZS1647F manual Slave Mode, Select Protocol Properties

2. Installation

2.7.6 Slave Mode

(1)Ensure that the board is connected to the fieldbus. Then, start the applicomIO console application.

(2)Click on the “Protocol list” under the board that was just added.

(3)Select Protocol Properties.

(4)Configure the baud rate, MAC ID (slave address), and so on for the DeviceNet network. In this example, the MAC ID (slave address) is set to 005.

NOTE

)(5)

Specify an unused address on the network for a slave device as well as other devices.

Double-click the “DeviceNet Local Slave” item.

Fieldbus I/O Rev.6 37