4. Troubleshooting (EtherNet/IP)

4.3.1 Examining a Problem

4.3.1.1 Scanner Board Diagnostic LEDs

The EtherNet/IP board used with EPSON RC+ has two status display LEDs. The layout of the LEDs is shown in the following figure.

PCU-ETHIO

4-pin Terminal

 

Watchdog Port

Jumper for Board Address

(Do not use this port.)

JP1

LED (2)

(Not in use)

 

D-Sub 9 pin

 

(Not in use)

JP1

Status Display LED (2)

0

 

 

1

EtherNetI/P Connector

C0 C1 C2

The Module/NetWork LED is on the left and the IO LED is on the right seen from the rear panel. These LED names are used in applicomIO Console application and this manual. Only in this troubleshooting section, general names of the status display of the DeviceNet device are used instead.

The Network Status LED is expressed by the NS LED (NS) in this section. The Module Status LED is expressed by the MS LED (MS) in this section.

Fieldbus I/O Rev.6

141

Page 153
Image 153
Epson EM07ZS1647F manual Examining a Problem