STEP 1 | Electricity Supply |
WARNING: The appliance must be earthed.
Fuses
Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only those rated at 13A and ASTA approved to BS1362 should be used. To change fuse lift holder to vertical position and lift fuse out. To replace, insert fuse and push fuse holder down into locked position. Correct replacement is identified by colour cod- ing or the marking on base of plug.
WARNING: Do not use plug unless fuse holder is in locked position.
Changing the Mains Lead
A special lead can be ordered from Hotpoint Service
UK: 08709 066 066 orRepublic of Ireland: 1850 302 200 If you have damaged the existing lead or require a longer one a charge will be made. It is strongly advised that this work is carried out by a qualified electrician.
Changing the Plug
Cut off and dispose of the supplied plug if it does not fit your socket.
WARNING: To avoid a shock hazard do not insert the discarded plug into a socket anywhere else.
IMPORTANT: WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Green/Yellow | - | Earth |
Blue | - | Neutral |
Brown | - | Live |
If you change the plug, the colour of wires in the mains lead may not correspond with the colour of the markings identifying terminals in the plug. You should therefore wire it as shown:
STEP 2
1 POLYSTYRENE BLOCK...
NOTE: YOU MAY NEED A SECOND PERSON TO HELP Y RAISE AND LOWER THE APPLIANCE.
This is part of the packaging and should have come away with the polystyrene base -
IF IT HAS NOT... REMOVE IT!
4
NOT
MO
ALO
W
Y
H
LEV
D
(*s
Green and yellow (Earth) wire to terminal marked ‘E’, symbol 
, or coloured green and yellow. 
Blue (Neutral) wire to 
terminal marked ‘N’ or
coloured black.
13A ASTA approved fuse to BS1362.
Brown (Live) wire to terminal marked ‘L’ or coloured red.
5
LEVEL?...
YOUR MACHINE WILL BE NOISY IF THE TW NOT ADJUSTED SO THE MACHINE STANDS
Each foot has two parts: The Locking Dis
Locking |
Disk |
Foot |
CE marking certifies that this appliance conforms to the following EEC directives:
Low Voltage Equipment - 72/23/EEC & 93/68/EEC
Electromagnetic Compatibility - 89/336/EEC, 92/31/EEC & 93/68/EEC
i | Release the locking disk on the | ii Turn |
| two front feet and screw the feet | on th |
| in or out until the machine stands | each |
| firm and level. | of the |
|
|
|
|
|
|