Hotpoint AQD1170F 697 E, AQD1170F 697 I instruction manual

Page 14

EN

The machine wont spin properly.

The machine leaks from the dispenser.

•Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

•The dispenser drawer is blocked with detergent and requires cleaning.

•The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again.

•The machine is tilting forwards - It must be level when in its final position.

The machine leaks (other than dispenser).

The Phase in Progress indicator lights flash rapidly at the same time as the ON/OFF indicator light.

The machine smells.

The machine door cannot be opened.

Door Seal damaged at the bottom.

The water level is too low when the machine is washing.

The word ‘dON’ appears intermittently in the display window and the drum slowly turns.

The machine just ‘beeps’ when a programme or option is selected (Child Lock Symbol is lit).

Clothes are coming out too wet on ‘Steam Refresh’ cycle.

There is too much foam.

•The fill hose is loose, check both the cabinet and tap ends.

•The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer.

•The drain hose is not fixed in properly.

•Switch off the machine and unplug it, wait for approximately 1 minute and then switch back on again. If the problem persists contact Technical Assistance Centre.

•The machine requires a service wash. Run a 90 degree wash cycle with detergent and no laundry.

•The door will not open until the door lock indicator light goes out shortly after the program has finished.

•If there is no power to the machine you need to perform the manual unlocking procedure (see Precautions & Tips).

•The door seal has drainage holes at the bottom - This is normal.

•The water level is correct if it can be seen at the bottom of the door.

•To exit, switch machine off, then press and hold ‘START/PAUSE’ and ‘ON/OFF’ buttons simultaneously for 3 seconds.

•Deactivate the Child Lock feature by pressing and holding in the ‘CHILD LOCK’ button for 2 seconds.

•Only dry items are to be used for this program. The program refreshes garments by removing bad odours and relaxing the fibres, also making items easier to iron if required.

•The detergent is not suitable for machine washing (it should display the text ‘for washing machines’ or ‘hand and machine wash’ or the like).

•Too much detergent was used - less detergent is required in soft water.

After completing the programme, or before starting a programme, the machine has turned itself off (no lights).

General.

•To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected.

•Your washing machine contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress). Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not have a wash label, or wash items that are not intended as machine washable.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Instructions for installation and use AqualtisUnpacking and levelling InstallationConnecting the electricity and water supplies Removing the plug Replacement fuse coversReplacing the fuse Disposing of the plugWith the following code How to connect an alternative plugAmp fuse, either in the plug or adaptor or at Disposing of the applianceTechnical data Description of the machine Main wash compartmentControl panel Temperature buttonHow to run a wash cycle or a drying cycle Wash Cycle Selector knobHow to run a wash cycle or a drying cycle Close the Porthole DoorWash options Wash cycles and optionsTable of wash cycles Easy IronPreparing the laundry Detergents and laundryEN Detergent Washing recommendationsLoad balancing system Precautions and tipsGeneral safety DisposalCare and maintenance Possible causes / Solutions Trouble shootingProblem Page GuaranteeEN Assistance195098453.01 You must register your appliance with us

AQD1170F 697 I, AQD1170F 697 E specifications

The Hotpoint AQD1170F 697 E and AQD1170F 697 I are advanced washer-dryer models that offer a combination of robust cleaning capabilities and innovative features. These appliances are designed to meet the demands of modern households while ensuring energy efficiency and user convenience.

One of the key features of the Hotpoint AQD1170F 697 E and I models is their generous load capacity. With the ability to handle up to 11 kg of washing and 7 kg of drying, these machines cater to larger family needs. This means that users can wash and dry larger batches of laundry in one go, saving both time and energy.

These models come equipped with a variety of wash programs tailored to different fabric types and levels of soiling. The dedicated cycles include options for cottons, synthetics, delicate garments, and even quick wash settings for when time is of the essence. The intelligent sensor technology optimizes water and energy consumption based on the load size, ensuring that resources are used efficiently.

Another remarkable aspect of the Hotpoint AQD1170F series is the Eco Cycle, which provides a more environmentally friendly wash option. This function is particularly beneficial for users who are keen on reducing their ecological footprint while still achieving excellent cleaning results.

The inverter motor technology integrated into these models enhances performance by reducing noise levels and vibrations during operation. This is especially advantageous for households with open-plan living spaces or during nighttime washing cycles. The durability of the inverter motor also contributes to the overall lifespan of the washer-dryer.

Both models also feature a delay start function, allowing users to set the machine to begin washing or drying at a later time, which can be particularly convenient for busy lifestyles. Smart controls and LED displays make it easy to navigate through the various settings and options, ensuring a user-friendly experience.

Furthermore, the Hotpoint AQD1170F 697 E and I are designed with safety features, including child lock options to prevent little hands from accidentally changing settings during operation.

In summary, the Hotpoint AQD1170F 697 E and AQD1170F 697 I washer-dryer models present a perfect blend of versatility, energy efficiency, and advanced technology, making them an excellent choice for modern families looking for a reliable laundry solution. With their impressive capacity and range of features, these machines promise to simplify the laundry process while delivering exceptional results.
Top Page Image Contents