Asko W6641 W661 CHILD-SAFESTART Button, CHILD-SAFE Menu Button, W6641 and W6661 Error Messages

CHILD-SAFESTART BUTTON

As a safety measure, you can program the W6641 and W6661 not to start unless the START button is held down for three seconds. To do this, follow the steps below:

1.Turn the machine off then on.

2.Press ENTER five times, then press P3 five times. (This must be done within 15 seconds.)

3.“Delayed start” displays with “0” flashing in the lower right corner. Press the right Arrow button to toggle the display to “3.”

CHILD-SAFE MENU BUTTON

Please note that when you set the child-safe Start button, the Menu button is automatically programmed to delay for three seconds before it becomes active. This prevents a child from accidentally changing the program settings.

When you want to change a program, press the Menu button for three seconds to activate the menus. The Menu button will work normally (without the 3-second delay) until you have completed your changes. If it is not pressed for two minutes, it will automatically revert back to the child-safe mode.

ENGLISH

W6641 AND W6661 ERROR MESSAGES

Error messages will display in the LCD window if faults			To remove the message, turn the power off or change
occur while a program is in progress. The table below			the program.
defines each possible error message.
	ERROR MESSAGE	SOLUTION
		When this symbol flashes at the lower right corner of the display it merely means
		the glass door isn’t closed securely. Close the door and try again.
0000		If this message flashes at the top right of the LCD window, the machine has failed
		to spin. This could be because the load is out of balance. Turn the power off
		then on again. Open the door and redistribute the washing. Run the Spin
		program again.
	Door lock fault	Call a service technician.
	Foaming	Run the Rinse program again.
		Try using less detergent and softener.
		Use low-sudsing detergents. (See page 8.)
	Overflow	Call a service technician
	Pressure sensor fault	Call a service technician.
	Temperature stop fault	Call a service technician.
	Thermistor fault	Call a service technician.
	Wash motor fault	Call a service technician.
	Water inlet fault	Make sure the water tap is open.
	Water outlet fault	Check the pin trap for possible blockage. Make sure the outlet hose isn’t kinked.

Page 17