AEG 12700 manual Installation, Unpacking, Positioning, Levelling, From the back

Page 24

Installation

Unpacking

All transit bolts and packing must be removed before using the appli- ance.

Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

Remove the

 

 

polystyrene

 

 

block from the

 

 

bottom of the

2

 

machine and

1

release the two

 

plastic bags

 

 

which are fixed

 

 

under the filter

 

 

door.

 

 

Carefully remove the right-hand bag (1) then the left-hand bag (2) by pulling them towards the centre of the machine.

Set the machine

upright and

remove the two remaining bolts

from the back.

Pull out the three plastic spacers from the holes into which the

bolts were fitted.

Plug the open holes with the plugs which you will find in the plastic bag containing the instruction booklet.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

Installation

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.

Levelling

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

46

47

Page 23 Page 25
Image 24
Page 23 Page 25
Contents ÖKO-LAVAMAT 12700 Turbo Electronic Contents Page Safety instructions General safetyChild safety Positioning, connection, starting upMain features of your washer-dryer DisposalTips for environmental protection Packaging materialsDescription of the appliance Control panel Front viewDelay Start button START/PAUSE buttonDrying Time button Programme Option buttonsDisplay Programme progress displayThetics and wool 900 rpm and for delicates 700 rpm Cancelling a programme Detergent dispenser drawerBefore the first wash Altering a programme which is runningPreparing the wash cycle Sorting out and preparing the laundryTypes of fabric and care labels Detergents and additives Preparing the drying cycle How to dry How to washSelection of the Delay Start option Selection of the desired wash programmeSelection of the spin speed or Rinse Hold option Relevant button the light corresponding toAutomatic washing and drying Starting the programmeNON-STOP programme Programme progress display At the end of the programmeProgramme chart Wash programmesSpecial programmes Consumption data for drying DryingCleaning and maintenance Frost precautions TroubleshootingProblem Possible cause Solution Something not working?Problem Possible cause SolutionUnsatisfactory washing results If grey stains remain on the laundryFoam is still visible even after the last rinse White residue is left on the laundryTechnical data ServiceWater pressure 50-800 kPa This appliance complies with the following EC directivesDimensions of the appliance Rear viewDoubt, do not use it and contact the retailer Installation UnpackingPositioning LevellingWater inlet Water drainageElectrical connection Permanent connection
Top Page Image Contents