English
Installing the Bottom Panel:
The purpose of the bottom panel installation is to block the noise and give you quite performance of the washer during the operation.
Steps:
1. You must first lay down the washer on its rear side.
2.Insert the panel to the bottom of the machine.
3.Get a screwdriver to tighten the screw in the hole of the panel and the unit at the bottom of the washer. (8 screws are supplied)
4.Once all screws are installed and the panel is set properly, return the washer to its standing position.
Installing Casters
Please follow the steps below to install the casters properly:
1. First lay the washer down with the left or right side facing up.
2. You will see 4 leveling legs. One located at the bottom of each corner. Turn each leveling leg one by one counterclockwise to remove.
3.Once all 4 leveling legs are removed properly, match the thread shaft of the caster to the bottom hole of the leveling leg.
4.Insert the caster into the hole and turn clockwise until it is tight. Repeat the same for each caster.
5.Once all wheels are installed and “casters” are set properly, return the washer to its standing position.
6.Each Caster comes with a lock. During the wash process you must lock all the casters so the washer can stay stable at one place and does not move away. Follow the procedure below to lock and unlock the casters.
A.To move your washer, keep the plastic clip on the caster at the upper position. This will release the lock.
B.To keep the washer stable at one place, keep the clip on the caster at the lower position in order to lock the washer.
23