Before You Call (continued) .................................
Stops
Leaks Water
Is Noisy
Fills with the Wrong Temperature Water
•Unevenly distributed load. Redistribute the load, close the lid and pull knob out. Check for leveling. Be sure water level is acceptable for load size.
•Plug cord into live electrical outlet.
•Check fuse or reset circuit breaker.
•Turn the control knob to proper cycle and pull knob out to start the washer. If equipped with buttons, be sure they are fully depressed.
•Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless lid is closed.
•This may be a pause or soak period in the cycle. Wait briefly and it may start.
•The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop fill operations for your safety. Call for service.
•Make sure hose connections are tight.
•Make sure end of drain hose is correctly inserted and secured to drain facility.
•Avoid extended soaking - soak for 30 minutes or less.
•Avoid overloading.
•Be sure washer is leveled properly as outlined in installation manual.
•Weak floors can cause vibration and walking.
•Be sure rubber feet are installed on leveling legs.
•Turn both faucets on fully.
•If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and not between settings.
•Make sure temperature selection is correct.
•Make sure hoses are connected to correct faucets and inlet connections. Be
sure water supply is regulated correctly. Flush water line before filling washer.
•Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate.
•Disconnect hoses and clean screens. Hose filter screens may be plugged.
For further help, call Maytag Customer Assistance: U.S.
U.S. customers using TTYJOr deaf, hearing impaired or speech impaired, call
9