IBM 6569 Diagnostic Error Code FRU/Action 014-013-XXX System board, 014-03X-XXX System board

Diagnostic Error Code	FRU/Action
014-013-XXX	1.	System board
014-014-XXXParallel port Control
Signal/Loopback test failure
014-015-XXXParallel port External Loopback	1.	Wrap plug
failure
	2.	System board
014-027-XXXParallel port Configuration/Setup	1.	Run Setup, enable port
error
	2.	Flash the system
	3.	System board
014-03X-XXX	1.	System board
014-04X-XXXParallel port failure
014-195-XXXParallel port Test aborted by user	1.	Information
	2.	Re-start the test, if necessary
014-196-XXXParallel port test halt, error	1.	Press F3 to review the log file
threshold exceeded
	2.	Re-start the test to reset the log file
014-197-XXXParallel port test warning	1.	Make sure the component that is called out is
		connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning statement
	4.	Component under test
014-198-XXXParallel port test aborted	1.	If a component is called out, make sure it is
		connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″ section
014-199-XXXParallel port test failed, cause	1.	Go to the ″Undetermined problems″ section
unknown
	2.	Flash the system and re-test
	3.	Replace component under function test
014-2XX-XXX	1.	External parallel device
014-3XX-XXXParallel port failure
	2.	System board
015-000-XXXUSB port Interface Test Passed	1.	No action
015-001-XXXUSB port Presence	1.	Remove USB device(s) and re-test
	2.	System board
015-002-XXXUSB port Timeout	1.	Remove USB device(s) and re-test
	2.	System board

Chapter 1. IBM PC Enhanced Diagnostics error codes 9