IBM 6649, 6578, 6579, 6269, 6059, 6058, 6569, 6568, 6648 Adapter card, Power-off/on system and re-test

Diagnostic Error Code	FRU/Action
001-027-XXXSystem Configuration/Setup error	1.	Run Setup
	2.	Flash the system
	3.	System board
001-032-XXXSystem Device Controller failure	1.	System board
001-034-XXXSystem Device Buffer Allocation	1.	Reboot the system
failure
	2.	Flash the system
	3.	Run memory test
	4.	System board
001-035-XXXSystem Device Reset condition	1.	System board
detected
001-036-XXXSystem Register error	1.	System board
001-038-XXXSystem Extension failure	1.	Adapter card
	2.	System board
001-039-XXXSystem DMI data structure error	1.	Flash the system
	2.	System board
001-040-XXXSystem IRQ failure	1.	Power-off/on system and re-test
	2.	System board
001-041-XXXSystem DMA failure	1.	Power-off/on system and re-test
	2.	System board
001-195-XXXSystem Test aborted by user	1.	Information
	2.	Re-start the test, if necessary
001-196-XXXSystem test halt, error threshold	1.	Press F3 to review the log file
exceeded
	2.	Re-start the test to reset the log file
001-197-XXXSystem test warning	1.	Make sure the component that is called out is
		connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning statement
	4.	Component under test
001-198-XXXSystem test aborted	1.	If a component is called out, make sure it is
		connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″ section

Chapter 1. IBM PC Enhanced Diagnostics error codes 3