IBM 6058, 6578, 6579, 6269 Diagnostic Error Code FRU/Action 011-013-XXX System board, Wrap plug

Diagnostic Error Code	FRU/Action
011-013-XXX	1.	System board
011-014-XXXSerial port Control
Signal/Loopback test failure
011-015-XXXSerial port External Loopback	1.	Wrap plug
failure
	2.	System board
011-027-XXXSerial port Configuration/Setup	1.	Run Setup, enable port
error
	2.	Flash the system
	3.	System board
011-03X-XXX	1.	System board
011-04X-XXXSerial port failure
011-195-XXXSerial port Test aborted by user	1.	Information
	2.	Re-start the test, if necessary
011-196-XXXSerial port test halt, error	1.	Press F3 to review the log file
threshold exceeded
	2.	Re-start the test to reset the log file
011-197-XXXSerial port test warning	1.	Make sure the component that is called out is
		connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning statement
	4.	Component under test
011-198-XXXSerial port test aborted	1.	If a component is called out, make sure it is
		connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″ section
011-199-XXXSerial port test failed, cause	1.	Go to the ″Undetermined problems″ section
unknown
	2.	Flash the system and re-test
	3.	Replace component under function test
011-2XX-XXXSerial port signal failure	1.	External serial device
	2.	System board
014-000-XXXParallel port Interface Test Passed	1.	No action
014-001-XXXParallel port Presence	1.	Remove external parallel device, if present
	2.	Run setup, enable port
	3.	System board
014-002-XXX	1.	System board
014-003-XXXParallel port Timeout/Parity error

8Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,

6649