IBM 6568, 6578, 6579, 6269, 6059 Diagnostic Error Code FRU/Action, Run setup and check for conflicts

Diagnostic Error Code	FRU/Action
015-015-XXXUSB port External Loopback	1.	Remove USB device(s) and re-test
failure
	2.	System board
015-027-XXXUSB port Configuration/Setup	1.	Flash the system
error
	2.	System board
015-032-XXXUSB port Device Controller failure	1.	System board
015-034-XXXUSB port bufferallocation failure	1.	Reboot the system
	2.	Flash the system
	3.	Run memory test
	4.	System board
015-035-XXXUSB port Reset condition detected	1.	Remove USB device(s) and re-test
	2.	System board
015-036-XXXUSB port Register error	1.	System board
015-040-XXXUSB port IRQ failure	1.	Run setup and check for conflicts
	2.	Flash the system
	3.	System board
015-195-XXXUSB port Test aborted by user	1.	Information
	2.	Re-start the test, if necessary
015-196-XXXUSB port test halt, error threshold	1.	Press F3 to review the log file
exceeded
	2.	Re-start the test to reset the log file
015-197-XXXUSB port test warning	1.	Make sure the component that is called out is
		connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning statement
	4.	Component under test
015-198-XXXUSB port test aborted	1.	If a component is called out, make sure it is
		connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″ section
015-199-XXXUSB port test failed, cause	1.	Go to the ″Undetermined problems″ section
unknown
	2.	Flash the system and re-test
	3.	Replace component under function test
018-000-XXXPCI Card Test Passed	1.	No action

10Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,

6649