IBM 6579, 6578, 6269, 6059, 6058, 6569, 6568, 6648, 6649 manual Setup Utility program

Message	Failure Found	Recommended Actions
2xx-2y	A memory error was detected in	Replace the DIMM/RIMM in the
	DIMM/RIMM socket Y	socket identified by the last digit
		of the error code.
		Re-run the test.
		If the same error code occurs
		again, replace the system board
		or where memory is on the
		processor card, replace the
		processor card.
Corrupt BIOS	Information in BIOS is not as	Reflash the BIOS.
	expected.	Perform boot block recovery.
	Not able to find expected DMI	Replace the system board.
	information from BIOS.
	Memory controller chipset
	vendor ID does not match
	expected value.
Test aborted by user	User stopped test.	Restart test.

Note: Y is the SIMM/DIMM/RIMM socket number. Use the System Board Layout section in the latest Hardware Maintenance Manual (HMM) to reference the memory sockets.

Setup Utility program

Attention

A customized setup configuration (other than default settings) might exist on the computer you are servicing. Running the Setup Utility program might alter those settings. Note the current configuration settings and verify that the settings are in place when service is complete.

The Setup Utility (configuration) program is stored in the permanent memory of the computer. This program includes settings for the following:

vSystem Summary

vProduct Data

vDevices and I/O Ports

vStart Options

vDate and Time

vSystem Security

Chapter 2. Types 6568/6569/6648/6649 41