Important
Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.
Levelling
Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level.
Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation.
Some vibration is inevitable, especially if mounted on a wooden floor.
Sprung wooden floors are particularly susceptible to vibration. For advice, consult a builder. If possible, always place the machine on a solid floor.
P0850 |
Special conditions
If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine.
Warning
The machine should NOT be placed on deep pile carpeting.
Note
Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
In the interest of the environment
Washing machines and dishwashers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.
It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.
If you require any further advice please contact your local authority drainage department.
SHOWER |
|
|
| SINK | TOILET |
BATH |
| BIDET |
WASHING | DISHWASHER | |
MACHINE | ||
RAINWATER |
|
|
|
| |
|
| FOUL DRAIN |
SURFACE WATER |
| FOUL SEWERS |
DRAINS & SEWERS |
| |
|
| |
|
| SEWAGE |
UNTREATED |
| TREATMENT |
DISCHARGE |
| WORKS |
|
| TREATED |
|
| DISCHARGE |
RIVER |
| RIVER |
|
| |
P0987 |
|
|
24