Unpacking
Before starting the machine up, the packing must be removed as follows.
You are advised to keep all the packaging for
Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on its back, making sure that the hoses are not squashed.
Remove the polystyrene block from the bottom of the machine.
Carefully slide out the right polythene bag (1).
Repeat the operation for the left polythene bag (2).
Remove the polystyrene base.
Set the machine upright and remove the two remaining bolts from the back.
Pull out the three plastic spacers from the holes into which the bolts were fitted.
Plug the open holes with the plugs which you can find at the back of the appliance.
Positioning
Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to suitable existing taps with the drain hose discharging into a sink.
The appliance has two inlet hoses, hot and cold, with female 3/4” BSP thread connectors. If this connection is not compatible with the plumbing of the existing installation, a variety of connectors are available from good hardware stores and plumbers merchants to suit most domestic plumbing. Any alteration to your existing plumbing must be carried out by a competent person, or qualified plumber.
P0255 |
P0234 |
P0256 |
2 | 1 |
P0233 |
|
P0020 |
22