FOR THE INSTALLER
Technical information
Dimensions | height with panel | 895 mm |
| height without panel | 850 mm |
| width | 397 mm |
| depth | 600 mm |
Power supply voltage / frequency | 230 V / 50 Hz | |
Total power absorbed |
| 2300 W (10 A) |
Heater rating |
| 1950 W |
Water pressure | minimum | 0,05 MPa (0,5 bar) |
| maximum | 0,8 MPa (8 bar) |
Maximum load | cotton | 5,0 kg |
| synthetics | 2,5 kg |
| wool | 1,0 kg |
Spinning speed |
| 550 rpm |
Electrical consumption (washing at 90°C) | 2,20 kWh | |
This appliance complies with the following EC Directive :
-72/23/EEC of 19.02.1973 -
-89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of the machine during transit must all be removed before using your machine for the first time. These parts and their securing means should be kept in case the machine has to be transported again.
Unpack the appliance. Tilt the appliance backwards. Give to one of the back corners a quarter turn. The appliance comes free naturally out the polystyrene basis. Take away this basis (fig. 1).
Open the lid of the appliance and remove the polystyrene and plastic wedges which block the drum. Close the lid (fig. 2).
On the back part and with a spanner, remove the two loosened spacers (A) (fig. 3).
Fig. 1 | Fig. 2 |
B
| A |
| +"#3 |
Fig 3 | Fig 4 |
The holes which are now visible must be closed with the plugs (B) provided with the appliance (fig. 4).
Please ensure that these parts have been removed from the machine and keep them in case of next transport (fig. 5).
If you want to keep the alignment of your appliance with the adjacent cupboards, you have the possibility to cut the crossbar holding the hoses located at the back of your washing machine (fig. 6).
Fig 5 | Fig 6 |
38