Operating Sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1.Connect the appliance.
2.Open the door (see picture).
All drying programmes end with a 10 minute cooling phase light 
is on).
You may remove the laundry after this phase. The lights 
, 
and 
illuminate.
8. If the laundry is not removed at the end of the |
cycle, the dryer performs an |
(duration: 30 minutes maximum). |
If you do not remove the laundry, the dryer will stop |
P1149 |
P1108 |
automatically at the end of the | ||
Lights , | and | remain lit and the buzzer |
sounds every 10 seconds for 2 minutes. | ||
The light of the “START/PAUSE” button goes | ||
off and a flashing zero appears on the display. | ||
9. Turn the programme selector dial to “0”; all the | ||
lights go out. The appliance is switched off. | ||
3.Load the items one at a time, shaking them out loosely.
4.Close the door. Please check the laundry does not get caught between the door and filter.
5.Select the drying programme or time. The lights
, 
and 
come on. The light of the “START/PAUSE” 
button flashes and the display shows the duration of the programme.
6.If required, press the low temperature button 
and/or the “Buzzer OFF”
button or the “Quick drying” button 
.
7.Press the “START/PAUSE” 
button the corresponding light stops flashing and drying starts.
Only the light 
remains lit. If you have selected the delayed start, the machine begins its countdown.
If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound, the programme phase indicator lights will flash.
The drum turns alternately in both directions during drying.
Remove the laundry. |
If you open and then close the door before |
turning the selector dial to “0” all the lights |
corresponding to the phases making up the |
performed programme come on and the |
display shows the duration of the programme. |
After each use
•Clean the filters (see page 10).
•Empty the water reservoir (see page 11).
Important!
If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position 
and wait until the end of this cooling phase before removing the laundry. This will avoid a 
and depress “START/PAUSE” 
button.
Modifying the programme
To change a programme which is running, first cancel it by turning the programme selector dial to “0”. Select the new programme and press the “START/PAUSE” 
button.
8