Installation
Positioning
It is recommended that, for your convenience, the machine is positioned close to your washing machine. Whilst drying, the tumble dryer will expel a certain amount of warm, very moist air, and this should be removed from the room as quickly as possible to prevent condensation. In an extremely well ventilated room or close to an open window, this may occur naturally. However, in general, it is better to carry the dryer's exhaust outside via the 100
mm diameter flexible hose supplied with |
the appliance; ending either temporarily |
at an open window, or permanently at a |
fixed ventilation grille, fitted to an exterior |
wall or window. The tumble dryer must |
be installed in a clean place, where dirt |
does not build up. Make sure there are |
Important:
When operating the tumble dryer, the room temperature must not exceed 35°C, as it may affect the performance of the appliance.
Fitting the vent hose
To simplify the installation, there is a choice of vent outlets: one at the back, the others in the left and
(A)from the vent outlet at the back, screwing it on to the hose and pushing it firmly back into place. The unused vents should now be sealed with the special snap covers provided.
no obstructing items or material near the |
(e.g. paper, rags etc.). To keep vibration |
and noise to a minimum when the dryer |
is in use, it should be placed on a firm, |
level surface. Once in its permanent |
operating position, check that the dryer |
28A
A
P1027
is absolutely level with the aid of a spirit |
level. If it is not, raise or lower the feet |
until it is. |
| The feet must never |
| be removed. Do not |
| restrict the floor |
| clearance through |
| deeppile carpets, |
| strips of wood or |
| similar. This might |
046 | cause heat |
|
which would interfere with the operation of the appliance.
Advice: If the hose is long and the room temperature low, the moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (dia. 3 mm) in the lowest point of the hose and to place a small container below it.(See picture, point B).
17