Zanussi ZDC37100W user manual Something not working, Malfunction Possible cause Solution

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.

During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working.

Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.

Malfunction		Possible cause	Solution
	• Mains plug is not		• Plug in at mains socket.
		plugged in or fuse is not	Check fuse in fuse box
Dryer does not work.		working correctly.	(domestic installation).
	• Loading door is open.		• Close loading door.
	•	Have you pressed the	• Press the START/PAUSE
		START/PAUSE button?	button again.
			• Select a different pro-
	• Wrong programme		gramme the next time
		selected.	you dry (see “Overview
	• Lint filter clogged.		of programmes” sec-
			tion).
	• Heat exchanger clogged
			• Clean lint filter.
		with lint.
			• Clean heat exchanger.
	• Incorrect volume of
Drying results		laundry.	• Observe recommended
	• Ventilation slots in base		loading volumes.
unsatisfactory.
		area covered up.	• Uncover ventilation
	• Residue on inside sur-		slots in base area.
		face of drum or drum	• Clean inside surface of
		ribs.	drum and drum ribs
	• Conductance of water at		• Re-programme stan-
		installation site differs	dard setting for degree
		from standard setting of	of drying (see
		machine.	‘Programming options’
			section).
Loading door does	• Fine strainer not in		• Install fine strainer
		place and/or large mesh	and/or snap large mesh
not close.
		filter not locked in place.	filter into place.

16