Zanussi ZDC 47100 S At the end of the programme, Remove the laundry, Modifying the programme

cleaned.

11. At the end of the programme

All drying programmes end with a 10 minute cooling phase.

You may remove the laundry after this phase. The lights Filter and Empty Tank, illuminate.

If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 min- utes maximum). If you do not remove the laundry, the dryer will stop auto- matically at the end of the anti-creasing phase.

The Lights Filter and The Empty Tank remain lit and the buzzer sounds for 2 minutes. Turn the programme selector dial to “Off” to switch the machine off.

Remove the laundry from the drum and carefully check that the drum is empty.

Turn the programme selector dial to “Off”; all the lights go out. The appli- ance is switched off.

12. Remove the laundry.

If you open and then close the door before turning the selector dial to“Off” all the lights corresponding to the phases making up the performed pro- gramme come on.

After each use

•Clean the filters.

•Empty the water reservoir.

Modifying the programme

To change a programme which is run- ning, first cancel it by turning the pro- gramme selector dial to “Off”. Select the new programme and press the Start button.

12