Malfunction | Possible cause | Solution |
|
|
|
When pressing a button, | • Washing protection. | • Turn the programme knob to |
the corresponding | After the start of the pro- | |
button flashes several | gramme, the option can no | OFF. Set the programme again |
times. | longer be set. |
|
Drying cycle ends | • Not enough washing | • Select time programme or |
shortly after programme | loaded | higher drying level (e.g. |
starts. END | or washing loaded is too | EXTRA DRY instead of CUP- |
light illuminated. | dry for selected programme. | BOARD). |
Programme inactive, | • Water reservoir is full. | • Empty the water reservoir, |
Condenser | then start programme with | |
light illuminated. |
| START/PAUSE button. |
Drying cycle lasts an | • Lint filter clogged. | • Clean lint filter |
unusually long time. | • Heat exchanger clogged | • Clean heat exchanger. |
Note: | with lint. | • DELICATE is only suitable for |
After around 5 hours | • DELICATE button pressed | use with loads of up to 3 kg! |
the drying cycle ends | and load volume too big. | • Reduce load volume. |
automatically (see | • Load volume too big. | • Laundry must be adequately |
„Drying cycle complete“) | • Laundry insufficiently spun. | |
|
|
|
If you are unable to identify or solve the problem, contact your local Service Centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information.
1206 |
Important:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
17