Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction | Possible cause | Solution | |
|
|
| |
| • Mains plug is not plugged in | • Plug in at mains socket. | |
| or fuse is not working correctly. | Check fuse in fuse box | |
Dryer does not work. | (domestic installation). | ||
• Loading door is open. | • Close loading door. | ||
| • Have you pressed the | ||
| • Press the START/PAUSE | ||
| START/ PAUSE button? | ||
| button again. | ||
|
| ||
|
|
| |
| • Wrong programme selected. | • Select a different programme | |
| the next time you dry. | ||
| • Lint filter clogged. | • Clean lint filter. | |
| • Heat exchanger clogged with | • Clean heat exchanger. | |
| lint. | • Observe recommended | |
| • Incorrect volume of laundry. | ||
Drying results | • Ventilation slots in base area | loading volumes. | |
• Uncover ventilation slots in | |||
unsatisfactory. | covered up. | base area. | |
| • Residue on inside surface of | • Clean inside surface of drum | |
| drum or drum ribs. | and drum ribs | |
| • Conductance of water at | ||
| • | ||
| installation site differs from | ||
| ting for degree of drying. | ||
| standard setting of machine. | ||
|
| ||
|
|
| |
Loading door does not | • Fine strainer not in place | • Install fine strainer and/or | |
close. | and/or large mesh filter not | snap large mesh filter into | |
locked in place. | place. | ||
| |||
|
|
|
16