Check these points if your Maytag Neptune TM washer...
Cycle Selector | • | Extra rinse option is selected. | |
Knob Advances | • | Washer will automatically provide an extra rinse when HEAVY/STAINS cycle and the | |
Through | "OFF" |
| STAIN CYCLE option button are selected. |
|
| • | Be sure the door is tightly closed. |
|
| • Plug cord into a live electrical outlet. | |
|
| • Check fuse or reset circuit breaker. | |
|
| • Turn the control dial to the proper cycle and push the START/STOP button. | |
|
|
| If equipped with buttons, be sure they are fully depressed. |
Won't | Fill | • | Make sure the control dial is set on a cycle starting point. Advance the dial slightly. |
|
| • Turn both faucets on fully. | |
|
| • Straighten inlet hoses. | |
|
| • Disconnect hoses and clean screens. Hose filter screens may he plugged. | |
|
| • Open and close the door, then push the START/STOP button. | |
|
| • Check fuse or reset circuit breaker. | |
|
| • Turn the control dial to proper cycle and push the START/STOP button. | |
Won't TUmble |
| If equipped with buttons, be sure they are fully depressed. | |
|
| • Close the door and push the START/STOP button. For your safety, the clothes washer | |
|
|
| will not tumble or spin unless the door is closed. |
|
| • Press the START/STOP button to stop the machine. | |
Door Locked Shut; | • | It may take 1 1/2 to 2 minutes for the door lock mechanism to disengage. | |
Will Not Open | • | When "Door Locked" light goes out, pull on the door indentation opposite the hinges, | |
•Open the door and wash the lower portion of the gray door seal with a solution of 1 cup chlorine bleach to 2 cups water.
•Select the following control panel setting: WHITES, Hot/Cold, Regular/Heavy/Stains cycle.
Freshening• Fill the bleach dispenser cup with liquid chlorine bleach and start the washer.
Your Washer | • | Pour an additional 1/2 cup bleach into the detergent dispenser as the washer is filling. |
| • Allow the washer to complete the cycle. | |
| • At the end of the cycle, open the door and dry the gray door seal. | |
| • Clothes washer should be leveled properly as outlined in installation instructions. | |
| • Check the leveling leg lock nuts are tightened. | |
Is Noisy | • | Be sure rubber feet are installed on leveling legs. |
| • Weak floors can cause vibration and walking. | |
| • | For information on normal operating sounds, see page 12. |
For further assistance, call Maytag Customer Service
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call
11