bSteps of using the operation buttons and description of the steps
How to change the direction of the drain hose
| 4 | SOAK | TIME REMAINED(MINUTES) | STANDARD |
| COTTON |
| |
| 3 | WASH |
| BLANKET |
|
|
| |
| 2 |
| 1HOUR |
|
| |||
|
|
|
|
|
|
|
| |
| 1 | RINSE |
| SAVE | 2HOURS |
| WER | |
|
|
|
| SILK |
|
| ||
|
| SPIN | RESERVE(HOURS LATER) |
|
| PO /OFF | ||
|
|
|
|
|
|
|
| ON |
WA |
|
|
|
|
| RT | ||
|
|
|
|
| STA | E | ||
| TER |
|
|
|
|
| US | |
LEVEL | PROCESS |
|
|
|
| PA |
| |
|
|
|
|
| AIR |
| ||
|
|
|
| PROGRAM | DRY |
| ||
|
|
| RESERVE |
|
|
| ||
|
|
|
|
|
|
|
| |
1.Dismantle the rear cover of the washing machine.
2.Put down the drain hose 
Take off the drain hose frame as indicated in Figure 1.Take the drain hose into the cabinet ,then nip the drain fixing clamp to make it deviated from the clip
the other hand is used to put down the drain bushing,as indicated in Figure 2,3.
3.Dismantle the drain outlet protecting cover at the other side, (the way is the same as the drain bushing),then install the drain bushing, as indicated in Figure 4.
4.Extend the drain hose from the other side. Fix the drain hose with drain hose frame onto the cabinet, as indicated in Figure 5.
4 |
|
| 7 |
|
| ||
3 | 5 | 2 | 6 |
| |||
|
|
Drain hose
Drain hose support | Drain bushing |
Figure 1 | Figure 2 |
Cabinet | |
Inner | Outer |
Drain outlet protecting cover
Figure 4 | Figure 5 |
Drain bushing
5.Install the drain outlet protecting cover to the other side, as indicated in Figure 6
| POWER |
1.Push "power" button to switch on the power | ON/OFF |
| |
2.Push "program" button to select suitable | PROGRAM |
|
|
After the power is switched on, "standard" is automatically set. To select other
push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11.
Push | Drain bushing |
Drain hose fixing | Take down |
| |
clamp | Figure 6 |
Push |
|
| Figure 3 |
Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman .
Usage the drain hose
E.g. Set to "SAVE"program for small quantity of laundries with light soil.
3 Push "Process" button to select suitable procedure program
PROCESS
Attention
Even there's no water in the tub, a certain period is required before spin starting.
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.
2.Do not step on or press the drain hose.
4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
Separate the laundries that are not colorfast from other laundries in washing.
The soak procedure can work in cooperation with automatic programs like standard, blanket cotton. There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing, and can not make setting in other cases.
3. If the drain hose is too long, cut it at mid point. To make 5.If the extra hose is too long, cut it either at A or at B. smooth drainage, cut the front end of the hose slantingly.
12 | 5 |