Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the bottom plate
4 Push the " water level" button, select suitable water level
WATER
LEVEL
After you open the package, please lean the washing machine gently downon soft items ( like the towel cloth, blanket, etc. ). Install the bottom plate to the bottom of the machine with the eight screws by a cross screwdriver, then lift the machine up gently. See to the figure:
Back
Front
Soft items | Screw | Bottom plate |
|
|
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth. After defection, it can set the water level automatically. To select other water level, first push the "start/pause" button, then push the "water level" button to set the water level.
5 Push the "reserve" button to select suitable reserve
wash program | RESERVE |
Adjust the Installation position
The largest allowable slope of the shank base of the machine is 2
.The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing procedure to be finished at reserved time, please push the " reserve "button to set the reserve wash program. Refer to reserve button in Page 10 for selection.
Confirm the operation of reserve program
When the "reserve" function is activated, the indicator light of the program you have set will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
Confirm it's horizontal:
Hang the lead line to check if it is horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
|
|
|
|
|
|
| the adjustable nut |
Loosen |
|
|
|
|
|
| Fasten |
|
|
|
|
|
| the adjustable leg | |
High |
|
|
|
| Low | ||
need to switch off the power and make new selection.
6 Push the "Air dry"button | AIR DRY |
|
Attention:
After switiching on the power,the function of the "Air dry" and "reserve"is not selected at the same time.
Only after the program with the spin is set,"Air dry"program can be selected;selecting the other program without spinning,"Air dry"program can not be selected that is the button of "Air dry"is no reaction.
7 Push the "Start/Pause" button | START |
PAUSE |
6 Finish washing
After finishing wash it'll alarm automatically