Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.

Install the bottom plate

After opening the package, please lean	the	I	Front
washing machine gently down on soft	items	I	Front
washing machine gently down on soft	items	I enlarge
(like towel cloth,blanket, etc.). Install the bottom
plate to the bottom of the machine with one		Carpet
screw by a cross screwdriver, then lift the machine
up gently. See to the figure:
			Back
		The two claws of bottom plate should
		insert the two strip holes ,and insure

Adjust the Installation position

The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:

Attention

Even there's no water in the tub, a certain period is required before spin starting.

Do not use the soak program for the woolen textiles.

Separate the laundries that are not colorfast from other laundries in washing.

The pulsator will not rotate unless the water is filled to"18L"water level.

The soak procedure can work in cooperation with automatic programs like standard,normal, jeans, and fiber . There is intermittent pulsator stirring during soak.

After the machine starts operation, you can only set the program and procedure during washing,soak and can not make setting in other cases.

3 Push the "PROCESS" button

You can choose one or more process among soak, wash, rinse, spin.
The button is invaid if you choose QUICK or	TUB DRY	program.
You can not choose soak process if you choose	WOOL	program.
4 Push the " WATER LEVEL"button, select suitable water level			WATER
			LEVEL

Confirm it's horizontal:

Hang the lead line to check if it is horizontal.

Adjust the adjustable leg:

1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.

2 . After adjustment, fasten the nut.

the adjustable nut

	Loosen	Fasten
	Loosen	the adjustable feet
		the adjustable feet
	High	Low

After switching on the power and the "standard"or" normal"programs set,washing machine will execute fuzzy

program automatically to detect the cloth.After defection, it can set the water level automatically. To select other

water level, first push the "start/pause" button, then push the "water level" button to

set the water level.

PROGRAM - SELF 5 Push the "SELF-PROGRAM"button and "+ " " -"button

to select suitable program

Set up time Of soaking, washing, dehydration and times of rinse you can also set up an appointment; set that means chosen the appointment booking functions, after start, the light of process you choose will be off, a digital displays the remaining appointment time (hours). Appointment process, holding down the "self-programming" button to display the status of an appointment that shows the procedure of your choice, water, process and the remaining time (minutes). Run the program to change or cancel an appointment,

need to cut off the power supply, re-select. In the light of article 11 can be "self-programming" button and select button "+""-".

6 Push the "START/PAUSE" button	STARTPAUSE

As the top lid opened, the washer will automatically given alarm and stop running, exclusively during draining

7 Finish washing

After the laundry process, washing machines beep alarm, and then automatically power off