WATER | 6 "START/PAUSE" button |
After the power is switched on, press it to start the machine | |
LEVEL | During working, push it to pause. |
| During pause, push this button to restart and go on working. |
How to change the direction of the drain hose
1.Loosen the screws of back cover, dismantle the back cover, then take off the drain hose (As indicated figure 1)
RESERVE(HOURS)
REMAIN(MINUTES)
REMAIN(MINUTES) indicator digitron
During sensing, it displays
During delay procedure, it displays the remained delay time (in hours).
During operation of programs, it displays the remaining time (in minutes).
In case of abnormal phenomenon, it displays the abnormal symbols
Figure 1
Drain hose 
frame
2.Take off the drain hose from base, nip flat the drain hose mouth, dismantle the hang hook, take the drain hose into cabinet from the left of base 
As indicated figure 2)
Figure 2
Steps of using the operation buttons and description of each step.
POWER
ON/OFF
1.Push the "POWER ON/OFF " button to switch on the power
It has the special power resume function. In the case of power failure or the power plug is loose during running , the machine can save the running program, and resume the program after the power supply is recovered. You do not need to set the program again.
2.Push the "PROGRAM" button to select the suitable | PROGRAM | |
automatic program |
| |
After switching on the power, the machine will set | STANDARD program automatically. To select other | |
nip flat the drain hose mouth, dismantle the hang hook
3.Extend the drain hose from the right side of base, fix the drain hose onto the base with the drain hose frame, and screw down the screws, put the hang hole onto the drain hose ,then hang up the drain hose.(As indicated in Figure 3)
Figure 3
4.Install the back cover as primary state.
Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman .
Usage the drain hose
automatic program, push the "PROGRAM" button till the relative indicator is light . Refer to the |
"PROGRAM "button on Page 10 for the selection. For instance: select "QUICK" program for laundries |
with small quantity and light soil. |
Page 10 |
In selecting the standard program, the machine will execute fuzzy program to select water level and wash time according to the cloth and weight of the laundries. The full process is controlled automatically.
Attention
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.
2.Do not step on or press the drain hose.
4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
Even there's no water in the tub, the spinning will start 
after a certain period.
Wash and spin after putting the damageable clothes 
into tuck net, to avoid scathe.
Wash the laundries that are prone to lose colors separately
from other laundries.
When washing start or opening cover intermitting, the washing machine will begin to work after a period time, this is normal phenomenon.
Only select rinse program,If there's water inside the tub, the machine will spin before rinsing ,If there's no water the machine will rinse directly.
3. If the drain hose is too long, cut it at mid point. To make 5.If the extra hose is too long, cut it either at A or at B. smooth drainage, cut the front end of the hose slantingly.
12 | 5 |