Haier HWM90-96A user manual Disposal after washing Usingi process, Please, Install it

Safety precautions Before Usingi

Disposal after washing Usingi process

Please plug the power plug on special receptacle. Be sure to use three-pins power receptacle. Ensure that the earthing prong of the power receptacle is earthed reliably. Use leakage protector if possible.

Earth

The washing machine must be positioned so that the plug is accessible. Be sure to pull the p l u g o ff a n d c l o s e t h e w a t e r f a u c e t i n following cases: power failure, delivering the machine, setting the machine idle or c l e a n i n g t h e m a c h i n e . D o n o t p l u g o r p u l l t h e p o w e r p l u g w i t h w e t h a n d .

After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine.

Please first pull off the power plug from the receptacle before cleaning.

Clean the detergent box and set it on	Please	keep the lint filter in good condition, and
the control panel seat.	install it	to proper position during washing. If the
1.The method of dismantle : Push it up aslant and gently.	lint filter is lost or damaged,please contact the local
2.The method of install : install it upwards and aslant	after-sales service department of our company.
and push it in .

Do not bend ,extend,twist,bind by force.Do not press or nip it with weight.

Keep the pin of the power plug clean,if the power plug is polluted with dust,please wipe with dry cloth carefully. If the power cord or the power plug is bad, to avoid risk it is

required to have it replaced by the technicians of our special shop or the after-sale service department.

In case the washing machine is installed on ground with			Do not use water hotter than 50
carpet, do not block the ventilation hole with carpet.
		T h e v e n t i l a t i o n
		holes at the bottom
		Soft object
	Do not put the machine at damp place like		Do not wash water-proof laundries like
	the bathroom. Never wash it with water. Do		the raincoat, bike covers etc. to avoid
	not put wet laundries on the control panel.		abnormal vibrations in spinning.

Do not let the machine share one receptacle with other electric appliances. If the plugging into the receptacle is loose, do not use the plug any more.

	The cover of lint filter	lint filter
	lint filter
Install	Dismantle

The back cover of lint filter

Dismantle

Install

DismantleInstall

The filter screen of the water inlet valve is likely to be	If the cabinet is dirty, wipe it with wet cloth
blocked by foreign materials and influence the water	Do not flush it directly with water.
inlet.	Wipe it with neutral detergent.
Please clean it with brush every two months.	Do not wipe it with thinner, petrol, alcohol etc.

Benzene

1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).

Please keep the lint filter in good condition, and install it to proper position during washing. If the lint filter is lost or damaged,please contact the local after-sales service department of our company.

The cover of lint filter lint filter

	lint filter
Install	Dismantle

The back cover of lint filter

Dismantle

Install

To prevent your laundries and washing machine from damages, be sure to take out all of the foreign materials from your pocket, such as coins, buttons, sandor hair pins etc.

Before washing, please check if the water tap is open, and if the water inlet pipe is connected properly.

It is suggested to use low-foaming washing powder.

2.Do not store water in the washing machine for a long period. Drain the water completely after each using.

3.Be sure to pull off the power plug before maintenance.

4.Hang up the power cord and drain hose.

5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time ( about 1 hour), then close the top lid.

2

15