English
3.Install the drain hose to the side of the washer using drain hose clamp. The drain hose must be placed into a drainpipe or sink at least 1 1/2 inches in diameter.
Use the gooseneck to hold hose in place. To avoid possible water back up, the drain hose must reach height of at least 31 1/2 inches minimum and 40 inches
maximum.
Water Inlet | Water Supply Hose | Goose Neck |
|
| “Y” Adapter |
|
| Hose Bend |
SINK
Drain Hose
Note: “Y Adaptor” shown in above figure is only for illustration. It is not provided in the box as an accessory. If you need to utilize this type of hookup, you can purchase a “Y Adaptor” from your nearest hardware store.
4. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet.
Note: Inspect carefully for any leaks around and back of the machine. If there is a leak then double check to see if any connections are loose. You may need to tighten loose connections.
CAUTION: If after completing these steps, you are unsure that unit is properly installed, contact a qualified installer. To ensure that your Washer is properly installed it is recommended that it be installed by a certified installer.
25